Virtual control method applied to Modular Multilevel Converter
The DC transformer based on the Modular Multilevel Converter (MMC) structure has the advantages of robust scalability, low output voltage harmonic content, easy realization of back-to-back connection, and high power transmission efficiency. It is widely used in DC distribution networks. However, tra...
Guardado en:
| Autores principales: | , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Elsevier
2022
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/025df3f63f69473db727e504bc1528bc |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | The DC transformer based on the Modular Multilevel Converter (MMC) structure has the advantages of robust scalability, low output voltage harmonic content, easy realization of back-to-back connection, and high power transmission efficiency. It is widely used in DC distribution networks. However, traditional control methods hardly provide inertia for the DC distribution network, thereby reducing the stability of the distribution network when new energy output fluctuations, DC distribution network failures, or other disturbances occur. Aiming at the problem that the DC bus voltage is easily affected by power fluctuations, the paper proposes a virtual inertia control method applied to the DC transformer with MMC structure. Similar to the introduction of virtual synchronous generators in the AC distribution network to enhance the system inertia, the paper designs a control strategy for dynamically adjusting the virtual inertia with a virtual capacitor added, which is based on the traditional two-phase shift control. The paper also presents the calculation method of the virtual capacitance. When the power in the DC microgrid fluctuates significantly, the strategy can effectively enhance the inertia of the DC distribution network and suppress the voltage fluctuation of the DC bus. The paper finally establishes a DC distribution network model with distributed power sources in the PLECS simulation software, and verifies the effectiveness of the control strategy compared with the traditional strategy. |
|---|