Effect of the gap width in AZ31 magnesium alloy joints obtained by friction stir welding
Thin AZ31 magnesium alloy sheets, i.e., 2 mm thick, are welded by Friction Stir Welding (FSW) in butt joint configuration using gap width up to 1.15 mm. All welds present good surface finishing and no internal defects, except for the weld produced using the maximum gap width. A reduction of the weld...
Guardado en:
Autores principales: | Fernanda Rocha Chiuzuli, Bruna Fernanda Batistão, Luciano Andrei Bergmann, Nelson Guedes de Alcântara, Jorge Fernandez dos Santos, Benjamin Klusemann, Piter Gargarella |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
Elsevier
2021
|
Materias: | |
Acceso en línea: | https://doaj.org/article/0395f57595f543ea86f9fe10ebed1b03 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Chord profile influence on the fatigue failure of a t-butt weld joint
por: Arzola de la Peña,Nelson, et al.
Publicado: (2014) -
Tensile Strength of Double Side Friction Stir Welding Using Varied Length of Pin and Rotating Directions
por: Djarot B. Darmadi, et al.
Publicado: (2021) -
Effect of welding parameters on mechanical properties of friction stir welded T-lap dissimilar metal joints between 7075 and 5083 aluminum alloys
por: Hao Dinh DUONG, et al.
Publicado: (2019) -
Investigations and optimization of friction stir welding process to improve microstructures of aluminum alloys
por: Bazani Shaik, et al.
Publicado: (2019) -
Local fatigue crack propagation behavior of a two-pass friction stir welded aluminum alloy
por: Milton MUZVIDZIWA, et al.
Publicado: (2014)