Experimental study on compressive properties of CFRP laminates at high temperatures <i>via</i> digital image correlation
The high-temperature compressive properties are indispensable mechanical performance parameters for the structural design of composites, but it is difficult to be measured effectively by traditional techniques. In this study, the high temperature compressive experiment of carbon fiber reinforced pla...
Guardado en:
| Autores principales: | , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | ZH |
| Publicado: |
Journal of Materials Engineering
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/06cb7e9cca45443b90ce3ae5a152a266 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | The high-temperature compressive properties are indispensable mechanical performance parameters for the structural design of composites, but it is difficult to be measured effectively by traditional techniques. In this study, the high temperature compressive experiment of carbon fiber reinforced plastics (CFRP) laminates was conducted in high-temperature experimental system based on digital image correlation (DIC) method. And the compressive properties, stress-strain curves and the evolution of axial full-field strain of CCF300/5228A with 0° and 90° ply-ups at 130℃ were obtained. Moreover, they were compared with those obtained at room temperature. Furthermore, the fracture analysis of the compressed specimens was carried out through scanning electron microscopy (SEM), meanwhile the effects of high temperature and lay-up on the compressive properties were discussed combining with the experimental results. Finally, an experimental verification was carried out and the results obtained demonstrated the feasibility and reliability of the experimental system and relevant experimental methods. The results show that the retention rate of 0° and 90° compressive strength at 130℃ are 70.5% and 62.6%, respectively, while the retention rate of compressive modulus are 88.0% and 75.4%, respectively, indicating that the strength and modulus of the laminates which are controlled by the matrix are more sensitive to high temperature. |
|---|