Wear Analysis of an Advanced Al–Al<sub>2</sub>O<sub>3</sub> Composite Infiltrated with a Tin-Based Alloy

Código QR

Wear Analysis of an Advanced Al–Al<sub>2</sub>O<sub>3</sub> Composite Infiltrated with a Tin-Based Alloy

In this study, a hybrid material is produced, and the effect of different loads varying from 40 to 60 N against an EN-31 steel counter disk on its wear behavior under dry sliding conditions at room temperature is studied. The tribological behavior is studied via the pin-on-disk method and analyzed u...

Descripción completa

Guardado en:

Detalles Bibliográficos
Autores principales:	Mihail Kolev, Ludmil Drenchev, Veselin Petkov
Formato:	article
Lenguaje:	EN
Publicado:	MDPI AG 2021
Materias:	Al–Al<sub>2</sub>O<sub>3</sub> tin-based babbitt tribological behavior mass wear specific wear rate Mining engineering. Metallurgy TN1-997
Acceso en línea:	https://doaj.org/article/076feca7729a431ab60fb18a4e3b46bf
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Masking Effect of LPSO Structure Phase on Wear Transition in Mg<sub>97</sub>Zn<sub>1</sub>Y<sub>2</sub> Alloy
por: Fujun Tao, et al.
Publicado: (2021)

Surface Structure and Electronic Properties of Lu<sub>3</sub>Al<sub>5</sub>O<sub>12</sub>
por: Weian Guo, et al.
Publicado: (2021)

Fracture Properties of α– and ĸ–Al<sub>2</sub>O<sub>3</sub> Hard Coatings Deposited by Chemical Vapor Deposition
por: Fabian Konstantiniuk, et al.
Publicado: (2021)

Methanation of CO<sub>2</sub> Using MIL-53-Based Catalysts: Ni/MIL-53–Al<sub>2</sub>O<sub>3</sub> versus Ni/MIL-53
por: Oana Grad, et al.
Publicado: (2021)

On the Impact of the Intermetallic Fe<sub>2</sub>Nb Laves Phase on the Mechanical Properties of Fe-6 Al-1.25 Nb-X W/Mo Fully Ferritic Light-Weight Steels
por: Robin Emmrich, et al.
Publicado: (2021)

The Effect of Heat Treatment on the Microstructure and Phase Composition of Plasma Sprayed Al<sub>2</sub>O<sub>3</sub> and Al<sub>2</sub>O<sub>3</sub>-TiO<sub>2</sub> Coatings for Applications in Biomass Firing Plants
por: Airingas Šuopys, et al.
Publicado: (2021)

Synergistic Adsorption-Catalytic Sites TiN/Ta<sub>2</sub>O<sub>5</sub> with Multidimensional Carbon Structure to Enable High-Performance Li-S Batteries
por: Chong Wang, et al.
Publicado: (2021)

Investigating the Nucleation of AlO<sub>x</sub> and HfO<sub>x</sub> ALD on Polyimide: Influence of Plasma Activation
por: Laura Astoreca, et al.
Publicado: (2021)

Corrosion of N10276 in a H<sub>2</sub>S, HCl, and CO<sub>2</sub> Containing Atmosphere at 480 °C and 680 °C
por: Manuela Nimmervoll, et al.
Publicado: (2021)

High-Stability Silver Nanowire–Al<sub>2</sub>O<sub>3</sub> Composite Flexible Transparent Electrodes Prepared by Electrodeposition
por: Honglong Ning, et al.
Publicado: (2021)

Corrosion Behavior of Cr<sub>19</sub>Fe<sub>22</sub>Co<sub>21</sub>Ni<sub>25</sub>Mo<sub>13</sub> Alloy in 1M Nitric Acid and 1M Hydrochloric Acid Solutions
por: Chun-Huei Tsau, et al.
Publicado: (2021)

Fabrication of Co<sub>3</sub>O<sub>4</sub>/NiCo<sub>2</sub>O<sub>4</sub> Nanocomposite for Detection of H<sub>2</sub>O<sub>2</sub> and Dopamine
por: Tianjiao Liu, et al.
Publicado: (2021)

Influence of Cross-Wind on CO<sub>2</sub> Arc Welding of Carbon Steel
por: Shinichi Tashiro, et al.
Publicado: (2021)

Joining Ti6Al4V to Alumina by Diffusion Bonding Using Titanium Interlayers
por: Marcionilo Silva, et al.
Publicado: (2021)

Effects of Primarily Solidified Dendrite and Thermal Treatments on the M<sub>23</sub>C<sub>6</sub> Precipitation Behavior of High-Chromium White Iron
por: Young-Gy Song, et al.
Publicado: (2021)

Preparation and Characterization of Tubelike g-C<sub>3</sub>N<sub>4</sub>/Ag<sub>3</sub>PO<sub>4</sub> Heterojunction with Enhanced Visible-Light Photocatalytic Activity
por: Xin Yan, et al.
Publicado: (2021)

Fabrication of La<sub>2</sub>O<sub>3</sub>/g-C<sub>3</sub>N<sub>4</sub> Heterojunction with Enhanced Photocatalytic Performance of Tetracycline Hydrochloride
por: Zhengru Zhu, et al.
Publicado: (2021)

Environmentally Benign Organic Dye Conversion under UV Light through TiO<sub>2</sub>-ZnO Nanocomposite
por: Sandip M. Deshmukh, et al.
Publicado: (2021)

Stabilization of Pt in SiO<sub>2</sub>–Al<sub>2</sub>O<sub>3</sub> Microspheres at High Mechanical Resistance, Promoted with W Oxides for the Combustion of CO
por: Arturo Pallares-García, et al.
Publicado: (2021)

Design and Modelling of Eco-Friendly CH<sub>3</sub>NH<sub>3</sub>SnI<sub>3</sub>-Based Perovskite Solar Cells with Suitable Transport Layers
por: M. Mottakin, et al.
Publicado: (2021)

The Electronic Structural and Defect-Induced Absorption Properties of a Ca<sub>2</sub>B<sub>10</sub>O<sub>14</sub>F<sub>6</sub> Crystal
por: Xuejiao Wang, et al.
Publicado: (2021)

CdIn<sub>2</sub>S<sub>4</sub>/In(OH)<sub>3</sub>/NiCr-LDH Multi-Interface Heterostructure Photocatalyst for Enhanced Photocatalytic H<sub>2</sub> Evolution and Cr(VI) Reduction
por: Rao Fu, et al.
Publicado: (2021)

Ionic Conductivity of Hybrid Composite Solid Polymer Electrolytes of PEO<sub><i>n</i></sub>LiClO<sub>4</sub>-Cubic Li<sub>7</sub>La<sub>3</sub>Zr<sub>2</sub>O<sub>12</sub> Films
por: Parisa Bashiri, et al.
Publicado: (2021)

MAS-NMR of [Pyr<sub>13</sub>][Tf<sub>2</sub>N] and [Pyr<sub>16</sub>][Tf<sub>2</sub>N] Ionic Liquids Confined to Carbon Black: Insights and Pitfalls
por: Steffen Merz, et al.
Publicado: (2021)

Reduction detection of H<sub>2</sub>O<sub>2</sub>based on Pt-Au-MoS<sub>2</sub>-ITO biosensor
por: LU Yan, et al.
Publicado: (2021)

Flexible Lead-Free Ba<sub>0.5</sub>Sr<sub>0.5</sub>TiO<sub>3</sub>/0.4BiFeO<sub>3</sub>-0.6SrTiO<sub>3</sub> Dielectric Film Capacitor with High Energy Storage Performance
por: Wenwen Wang, et al.
Publicado: (2021)

The Study of C<sub>3</sub>H<sub>6</sub> Impact on Selective Catalytic Reduction by Ammonia (NH<sub>3</sub>-SCR) Performance over Cu-SAPO-34 Catalysts
por: Yingfeng Duan, et al.
Publicado: (2021)

Separable Magnetic Fe<sub>3</sub>O<sub>4</sub>@MoS<sub>2</sub> Composite for Adsorption and Piezo-Catalytic Degradation of Dye
por: Chi Zhou, et al.
Publicado: (2021)

Timber Properties and Cellulose Crystallites Size in Pine Wood Cut in Different Sawing Patterns after Pretreatment with CH<sub>3</sub>COOH and H<sub>2</sub>O<sub>2</sub> and Densification
por: Andi Detti Yunianti, et al.
Publicado: (2021)

Pressure Tuned Structural, Electronic and Elastic Properties of U<sub>3</sub>Si<sub>2</sub>C<sub>2</sub>: A First Principles Study
por: Moran Bu, et al.
Publicado: (2021)

Preparation of Multilayered Core–Shell Fe<sub>3</sub>O<sub>4</sub>-SnO<sub>2</sub>-C Nanoparticles via Polymeric/Silane–Amino Functionalization
por: Jae Uk Hur, et al.
Publicado: (2021)

Photodetector Based on CsPbBr<sub>3</sub>/Cs<sub>4</sub>PbBr<sub>6</sub> Composite Nanocrystals with High Detectivity
por: Yue Han, et al.
Publicado: (2021)

Ga<sub>2</sub>O<sub>3</sub>(Sn) Oxides for High-Temperature Gas Sensors
por: Nataliya Vorobyeva, et al.
Publicado: (2021)

Keggin-Al<sub>13</sub> Polycations: Influence of Synthesis and Intercalation Parameters on the Structural Properties of Al-Pillared Clays
por: Anderson Parodia, et al.
Publicado: (2021)

Mechanochemically Prepared Co<sub>3</sub>O<sub>4</sub>-CeO<sub>2</sub> Catalysts for Complete Benzene Oxidation
por: Lyuba Ilieva, et al.
Publicado: (2021)

Effect of Adding Chelating Ligands on the Catalytic Performance of Rh-Promoted MoS<sub>2</sub> in the Hydrodesulfurization of Dibenzothiophene
por: Siphumelele Majodina, et al.
Publicado: (2021)

Improvement in the Resistance to Wear of Work-Rolls Used in Finishing Stands of the Hot Strip Mills
por: Alberto Cofiño-Villar, et al.
Publicado: (2021)

Annealing Studies of Copper Indium Oxide (Cu<sub>2</sub>In<sub>2</sub>O<sub>5</sub>) Thin Films Prepared by RF Magnetron Sputtering
por: Giji Skaria, et al.
Publicado: (2021)

A Double-Deck Structure of Reduced Graphene Oxide Modified Porous Ti<sub>3</sub>C<sub>2</sub>T<sub>x</sub> Electrode towards Ultrasensitive and Simultaneous Detection of Dopamine and Uric Acid
por: Yangguang Zhu, et al.
Publicado: (2021)

Measurement of Solubility of CO<sub>2</sub> in NaCl, CaCl<sub>2</sub>, MgCl<sub>2</sub> and MgCl<sub>2</sub> + CaCl<sub>2</sub> Brines at Temperatures from 298 to 373 K and Pressures up to 20 MPa Using the Potentiometric Titration Method
por: Bo Liu, et al.
Publicado: (2021)