Preface

Código QR

Preface

Guardado en:

Detalles Bibliográficos
Autor principal:	Yoshihisa NISHI
Formato:	article
Lenguaje:	EN
Publicado:	The Japan Society of Mechanical Engineers 2021
Materias:	Mechanical engineering and machinery TJ1-1570
Acceso en línea:	https://doaj.org/article/0a6dd60f48e54d97ab42a7be1352521e
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Preface
por: Koji Kato
Publicado: (2006)

Preface to the Special Issue on WTC 2017
por: Editor-in-Chief
Publicado: (2018)

Preface to the Special Issue on Automotive Tribology
Publicado: (2017)

Stability analysis of triple solutions of Casson nanofluid past on a vertical exponentially stretching/shrinking sheet
por: Hazoor Bux Lanjwani, et al.
Publicado: (2021)

A three-dimensional thermal analysis for cooling a square Light Emitting Diode by Multiwalled Carbon Nanotube-nanofluid-filled in a rectangular microchannel
por: Mohamed Bechir Ben Hamida, et al.
Publicado: (2021)

A numerical study of droplet splitting in branched T-shaped microchannel using the two-phase level-set method
por: Mohammad Raad, et al.
Publicado: (2021)

Design and Validation of a Novel Cable-Driven Hyper-Redundant Robot Based on Decoupled Joints
por: Long Huang, et al.
Publicado: (2021)

Mobile Robot Obstacle Avoidance Based on Neural Network with a Standardization Technique
por: Karoline Kamil A. Farag, et al.
Publicado: (2021)

Research on trajectory planning of closed loop grouting robot
por: Runmei Zhang, et al.
Publicado: (2021)

Study of geometrical defects of free-form surface machined using neural network
por: Benattia Bloul, et al.
Publicado: (2021)

Induction motor condition monitoring using infrared thermography imaging and ensemble learning techniques
por: Amine Mahami, et al.
Publicado: (2021)

Mean curvature effect on the response and failure of round-hole tubes submitted to cyclic bending
por: Kuo-Long Lee, et al.
Publicado: (2021)

Modeling and parameter identification of seated human body with the reference vector guided evolutionary algorithm
por: Shuguang Zhang, et al.
Publicado: (2021)

Non-isothermal rarefied gas flow in microtube with constant wall temperature
por: Iva Guranov, et al.
Publicado: (2021)

A generalized meshing analysis method and its application to toroidal surface enveloping conical worm drive
por: Chongfei Huai, et al.
Publicado: (2021)

Design and test of hydro-pneumatic ISD suspension in heavy multi-axle vehicles
por: Jiamei Nie, et al.
Publicado: (2021)

Atypical start-up experiments on pump as turbine
por: Yu-Liang Zhang, et al.
Publicado: (2021)

Analysis on the escape phenomenon of oil mist from turbine lower guide bearing based on VOF model
por: Jiayang Pang, et al.
Publicado: (2021)

Analysis of Timoshenko beam with Koch snowflake cross-section and variable properties in different boundary conditions using finite element method
por: Hossein Talebi Rostami, et al.
Publicado: (2021)

Displacement prediction and optimization of a non-circular planetary gear hydraulic motor
por: Biao Zhang, et al.
Publicado: (2021)

State of the art methods to post-process mechanical test data to characterize the hot deformation behavior of metals
por: Shahin Khoddam, et al.
Publicado: (2021)

Flutter speed prediction by using deep learning
por: Yi-Ren Wang, et al.
Publicado: (2021)

Using finite element analysis to discuss the study of drawing of servo stamping curve
por: Dyi-Cheng Chen, et al.
Publicado: (2021)

Numerical study of natural convection nanofluids flow in tilted cavities with a partially thermally heat source
por: Djamila Benyoucef, et al.
Publicado: (2021)

A novel fault-tolerant control strategy based on inverse bicausal bond graph model in linear fractional transformation
por: Yacine Lounici, et al.
Publicado: (2021)

Grey Wolf Resampling-Based Rao-Blackwellized Particle Filter for Mobile Robot Simultaneous Localization and Mapping
por: Yong Dai, et al.
Publicado: (2021)

Erratum: Zhu, Y.; Pal, J. Low-Voltage and High-Reliability RF MEMS Switch with Combined Electrothermal and Electrostatic Actuation. <i>Micromachines</i> 2021, <i>12</i>, 1237
por: Yong Zhu, et al.
Publicado: (2021)

Experimental results of the effect of gas composition on void fraction and bubble behavior for gas-liquid two-phase flow under stagnant water condition
por: Miki SAITO, et al.
Publicado: (2021)

Reliability of MEMS in Shock Environments: 2000–2020
por: Tianfang Peng, et al.
Publicado: (2021)

Greentelligence: Smart Manufacturing for a Greener Future
por: Xingyu Li, et al.
Publicado: (2021)

New FMEA Risks Ranking Approach Utilizing Four Fuzzy Logic Systems
por: Jelena Ivančan, et al.
Publicado: (2021)

Analysis, Modeling, and Simulation of Thin-Film Cells-Based Photovoltaic Generator Combined with Multilayer Thermoelectric Generator
por: Yasir Musa Dakwar, et al.
Publicado: (2021)

Tissue Engineering Meets Nanotechnology: Molecular Mechanism Modulations in Cornea Regeneration
por: Olja Mijanović, et al.
Publicado: (2021)

['Some practical crack path examples']
Publicado: (2013)

['Numerical modelling in non linear fracture mechanics']
Publicado: (2013)

['Notiziario n. 18 - Luglio 2007']
Publicado: (2013)

['Sulla storia degli studi di frattura in Italia']
Publicado: (2013)

An Algorithm for Tracking the Position and Velocity of Multiple Neuronal Signals Using Implantable Microelectrodes In Vivo
por: Lionel M. Broche, et al.
Publicado: (2021)

FPGA Implementation of Threshold-Type Binary Memristor and Its Application in Logic Circuit Design
por: Liu Yang, et al.
Publicado: (2021)

Research on the Force-Sensitive Characteristic of InAs QD Embedded in HEMT
por: Rui-Rong Wang, et al.
Publicado: (2021)