Optimization of Abrasive Water Jet Machining of SiC Reinforced Aluminum Alloy Based Metal Matrix Composites Using Taguchi–DEAR Technique
Since the importance of introducing new engineering materials is increasing, the need for machining such higher strength materials has also considerably increased. In the present research, an endeavor was made to introduce a Taguchi–DEAR methodology for the abrasive water-jet machining process, whil...
Guardado en:
Autores principales: | Muthuramalingam Thangaraj, Mahmoud Ahmadein, Naser A. Alsaleh, Ammar H. Elsheikh |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
MDPI AG
2021
|
Materias: | |
Acceso en línea: | https://doaj.org/article/0c81b949e08a4dd4b121c8a2464d1d3a |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
A High-Performance SiC Super-Junction MOSFET With a Step-Doping Profile
por: Hao Huang, et al.
Publicado: (2021) -
Experimental Determination of Interface Trap Density and Fixed Positive Oxide Charge in Commercial 4H-SiC Power MOSFETs
por: Susanna Yu, et al.
Publicado: (2021) -
M-Center in Neutron-Irradiated 4H-SiC
por: Ivana Capan, et al.
Publicado: (2021) -
Impact of PWM Voltage Waveforms on Magnet Wire Insulation Partial Discharge in SiC-Based Motor Drives
por: Mohamed Diab, et al.
Publicado: (2021) -
Effect of Impurities Control on the Crystallization and Densification of Polymer-Derived SiC Fibers
por: Young-jun Joo, et al.
Publicado: (2021)