New Copper Alloys Used to Make Products Intended for Contact with Drinking Water
This article presents the results of tests conducted as part of a research project with the primary objective of developing new copper alloys with limited lead content. The new group of materials were created in a production plant. As part of tests, a group of 22 alloys were selected for testing in...
Guardado en:
Autores principales: | Michał Chruściński, Szymon Szkudelski, Jacek Borowski, Artur Meller, Marcin Suszyński |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
MDPI AG
2021
|
Materias: | |
Acceso en línea: | https://doaj.org/article/21ffe0c495244906945baf0ff76efea6 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Effect of 6061 aluminum alloy wheel forging and spinning process parameters on forming quality
por: S. Y. Chen, et al.
Publicado: (2022) -
A Novel Technique for Controllable Fabrication of Multilayer Copper/Brass Block
por: Jiansheng Li, et al.
Publicado: (2021) -
Wear Analysis of Forging Tools Used in an Industrial Production Process—Hot Forging in Closed Dies of the “Head-Disk” of an Engine Valve Forging
por: Marek Hawryluk, et al.
Publicado: (2021) -
Behavior of asymmetric deformation of rod in locally-lateral upsetting
por: Takashi NOMURA, et al.
Publicado: (2016) -
Reduction of Die Wear and Structural Defects of Railway Screw Spike Heads Estimated by FEM
por: Jackeline Alcázar, et al.
Publicado: (2021)