Effect of channel geometries on two-phase mixture level swell and its fluctuation amplitude
Gas–liquid two-phase flow in a stagnant pool is an important phenomenon in designing and operating industrial facilities. When gas is mixed or boiling occurs in stagnant water, the actual water level appears higher than the original water level. The actual water level is called a two-phase mixture l...
Guardado en:
| Autores principales: | , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
The Japan Society of Mechanical Engineers
2020
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/2fb8de8b1e524695acb6e741bad6ce60 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Gas–liquid two-phase flow in a stagnant pool is an important phenomenon in designing and operating industrial facilities. When gas is mixed or boiling occurs in stagnant water, the actual water level appears higher than the original water level. The actual water level is called a two-phase mixture level and largely depends on the flow channel geometries, dimensions, and flow conditions. This study focuses on the influence of channel geometries, circular pipes and rod bundles, on the two-phase mixture level and its fluctuation behavior. An air–water experiment using circular pipes with inner diameters of 50 and 224 mm and 5 × 5 and 10 × 10 rod bundles was conducted, and the two-phase mixture level swell was visually observed. As the inlet gas flow rate increased, the two-phase mixture level basically increased regardless of the channel geometry. The fluctuation amplitude was remarkably increased by formulating the slug bubbles covering the entire diameter in the small pipe with a diameter of up to 50 mm. In the rod bundles and large pipe with a diameter of 224 mm, no slug bubble was sustained, and the two-phase water level and its fluctuation amplitude were relatively small compared with those of the small pipe. |
|---|