The effects of hot water pre-extraction and alkaline catalyzed on soda-AQ pulping of kenaf whole stem

In the present study the effects of hot water pre-extraction and alkaline catalyzed were evaluated on soda-aq pulping of kenaf whole stem. In this respect, following kenaf chips pre-extraction at various temperature and time conditions, pulp preparation were carried out on oven-dried weight loss lev...

Descripción completa

Guardado en:
Detalles Bibliográficos
Autores principales: Mohammad taghi Asdolah zadeh, Hossein Resalti, Ali Ghasemian
Formato: article
Lenguaje:FA
Publicado: Regional Information Center for Science and Technology (RICeST) 2011
Materias:
Acceso en línea:https://doaj.org/article/3cdbf919b4bd45a7820324ae595e40c5
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Descripción
Sumario:In the present study the effects of hot water pre-extraction and alkaline catalyzed were evaluated on soda-aq pulping of kenaf whole stem. In this respect, following kenaf chips pre-extraction at various temperature and time conditions, pulp preparation were carried out on oven-dried weight loss levels of 8.5, 11.5 and 14.5 % of the samples, and the reference untreated kenaf chips performed by using Soda-AQ at 3 levels of H-factors ( 983, 1408 and 1832 hours). Results indicated that kenaf chips weight losses increased while the pre-extracted pH decreased as pre-extraction temperature and time increased. The required H-factor for achieving certain level of weight loss was reduced by adding small amounts of alkali (0.15 % on oven dried kenaf) on hot water extraction stage. The Pulp yields were reduced by increasing cooking H-factor and extracted weight loss. Averages comparison indicated that significant differences were observed, at 95% confidence, between the pulp yield and kappa number from reference pulp and pre-extracted pulp samples at levels of about 8.5, 11.5 and 14.5 %, and pulp yields and their kappa number were higher in reference pulps than pre-extracted samples. In addition, pulp yield average was higher in pre-extracted samples by alkaline catalyzed than pre-extracted samples by hot water, however, no significant differences were observed between their kappa number average. Meanwhile, to obtain a certain (similar) kappa number, pre-extracted kenaf chips in comparison with reference untreated kenaf chips require lower H-factor.