Analysis of borehole stability in gas drilling using a thermal elastoplastic coupling model

Abstract Gas drilling causes lower pressure in the borehole and the Joule‐Thomson effect to occur at the bit nozzle, resulting in a temperature distribution in the borehole different from that in the original formation. The borehole temperature is far lower than the original formation temperature ne...

Descripción completa

Guardado en:
Detalles Bibliográficos
Autores principales: Zhongxi Zhu, Chaofei Wang, Yuchen Ye, Wanneng Lei
Formato: article
Lenguaje:EN
Publicado: Wiley 2021
Materias:
T
Q
Acceso en línea:https://doaj.org/article/425748b925b8406899d045732bf5d732
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Descripción
Sumario:Abstract Gas drilling causes lower pressure in the borehole and the Joule‐Thomson effect to occur at the bit nozzle, resulting in a temperature distribution in the borehole different from that in the original formation. The borehole temperature is far lower than the original formation temperature near the bottom of the borehole. This temperature difference leads to thermal stress on the borehole. The borehole temperature is higher than the formation temperature in the upper part of the borehole, causing the surrounding rock to expand because of the resulting thermal stress, which enhances the expansion of the surrounding rock into the borehole. The force supporting the borehole wall is thus weaker, and the borehole inevitably deforms under the original in situ stress. Meanwhile, the complete stress‐strain process of rock can be simplified into three linear stages: elasticity, plasticity, and residual. According to the combination of the Tresca yield criterion and the thermal stress, a thermal elastoplastic coupling model was developed to calculate the radii of the plastic softening and broken zones. An example calculation showed that the shrunken thermal stress at the bottom of the borehole could enhance the stability of the borehole wall, while the expansive thermal stress at the top could increase the instability of the borehole. When thermal stress was considered, the thermal elastoplastic model of rock was more consistent with the field measurements than when it was neglected.