Formation of Compressive Residual Stress by Face Milling Steel AISI 1045
Abstract Machining residual stresses correlate very closely with the cutting parameters and the tool geometries. This research work aims to investigate the effect of cutting speed, feed rate and depth of cut on the surface residual stress of steel AISI 1045 after face milling operation. Aft...
Guardado en:
Autores principales: | Ahmed Naif Al-Khazraji, Samir Ali Al-Rabii, Samir Zidan Al-Fahadawy |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
Al-Khwarizmi College of Engineering – University of Baghdad
2017
|
Materias: | |
Acceso en línea: | https://doaj.org/article/4939b04570614834a070e3eaa4c71775 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Formation of Compressive Residual Stress by Face Milling Steel AISI 1045
por: Samir Zidan Al-Fahadawy, et al.
Publicado: (2015) -
Enhancement of Buckling Resistance of Aluminized Long Columns of Stainless Steel AISI 303
por: Ahmed Naïf Al-Khazraji, et al.
Publicado: (2016) -
Improvement of Dynamic Buckling Behavior of Intermediate Aluminized Stainless Steel Columns
por: Ahmed Naif Al-Khazraji, et al.
Publicado: (2017) -
Studying and Modeling the Effect of Graphite Powder Mixing Electrical Discharge Machining on the Main Process Characteristics
por: Ahmed N. Al-Khazraji, et al.
Publicado: (2015) -
Studying and Modeling the Effect of Graphite Powder Mixing Electrical Discharge Machining on the Main Process Characteristics
por: Ahmed N. Al-Khazraji, et al.
Publicado: (2015)