Comparison of STM’s reliability system on the example of selected element

This paper presents optimization of the reliability system for different Strut and Tie models of beams loaded with a torsional and bending moment. In this paper, three STMs depending on the angle of diagonal strut were compared. The presented beam models have a serial system reliability. In the anal...

Descripción completa

Guardado en:
Detalles Bibliográficos
Autor principal: Buda-Ożóg Lidia
Formato: article
Lenguaje:EN
Publicado: De Gruyter 2020
Materias:
Acceso en línea:https://doaj.org/article/4e5c1f7878044b5d8ced5c0a14c675ca
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Descripción
Sumario:This paper presents optimization of the reliability system for different Strut and Tie models of beams loaded with a torsional and bending moment. In this paper, three STMs depending on the angle of diagonal strut were compared. The presented beam models have a serial system reliability. In the analyses, the full correlation of the top chord of truss - upper reinforcement, full correlation of bottom chord of truss - compression concrete, full correlation of members mapping individual stirrups and concrete in diagonals between stirrups. Estimation of the reliability of the adopted structures was carried out in a software package of Strurel. The variables of concrete, and steel strength as well as concentrated load magnitude were described by a mean value, a standard deviation and a type of distribution. Summing up the results of the analysis, it was noted, that methods for reliability estimation using information about the model’s reliability structure are an excellent alternative to time consuming simulation methods. These methods allow not only to estimate the reliability of the structure, but also to determine the impact of individual members on the reliability of the entire element.