Impact-Sliding of Sintered Steel: Effect of Lubrication
Sintered steel is used as a material for valve seat insert in automotive engines. During operation, a dynamic contact occurs between the valve and its seat. To investigate the wear behavior of sintered steel for this application, we have developed an impact-sliding tester using a ball on flat config...
Guardado en:
| Autores principales: | , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Japanese Society of Tribologists
2013
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/508e7b7d13c2464caaa4975141e66090 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Sintered steel is used as a material for valve seat insert in automotive engines. During operation, a dynamic contact occurs between the valve and its seat. To investigate the wear behavior of sintered steel for this application, we have developed an impact-sliding tester using a ball on flat configuration. Impact-sliding experiments have been conducted at different impact angles (30°, 45°, 60°) with and without lubrication to investigate the surface damage of the sintered steel under this contact loading and to understand the effect of lubrication. Our results have shown an important variation of the wear rate in relation to impact-sliding angle. In dry condition, a low wear regime is observed for low angles; whereas maximum wear is observed at 60° angle for lubricated contacts. The wear scar in the dry contact is deeper than in the lubricated one. The damaged surface of sintered steel is examined by a Scanning Electron Microscopy (SEM). In dry conditions, the contact area wears out quickly due to an adhesive-abrasive process. Under lubricated conditions, a fatigue crack opening is associated to a lower wear rate. The lubricated impact-sliding condition modifies the main surface damage phenomena. |
|---|