Effect of scan speed on grain and microstructural morphology for laser additive manufacturing of 304 stainless steel
The laser scanning parameters used in laser additive manufacturing (LAM) can impact the growth direction of the columnar grains produced during rapid solidification. This growth direction affects the mechanical properties of the manufactured parts after cladding. The effective use of a high laser po...
Guardado en:
Autores principales: | Chai Rongxia, Zhang Yapu, Zhong Bin, Zhang Chuanwei |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
De Gruyter
2021
|
Materias: | |
Acceso en línea: | https://doaj.org/article/54755e21e8c441cdb37af62da13a5e89 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Strengthening control in laser powder bed fusion of austenitic stainless steels via grain boundary engineering
por: Hossein Eskandari Sabzi, et al.
Publicado: (2021) -
Size effect due to contour laser scanning in 316L stainless steel produced by laser powder bed fusion
por: Jaehyun Yu, et al.
Publicado: (2021) -
Intensive laser repair through additive manufacturing of high-strength martensitic stainless steel powders (I) –powder preparation, laser cladding and microstructures and properties of laser-cladded metals
por: Jie Ning, et al.
Publicado: (2021) -
The study of hot deformation on laser cladding remanufactured 316L stainless steel
por: Yuehan Liu, et al.
Publicado: (2021) -
Influence of Welding Process on Microstructure and Properties of Laser Welding of SiCp/6061 Al Matrix Composite
por: Hongliang Li, et al.
Publicado: (2021)