Triaxial creep tests of glacitectonically disturbed stiff clay – structural, strength, and slope stability aspects
This study concerns the creep impact on strength parameters of the selected very cohesive soils (PI = 30–70%). The analysis refers to Neogene clays characterized by a complex structure, resulting directly from a complicated load history in the geological time scale and identified glacitectonic defor...
Guardado en:
| Autores principales: | , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
De Gruyter
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/5fc7c62673194d3782d7360a89c231cd |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | This study concerns the creep impact on strength parameters of the selected very cohesive soils (PI = 30–70%). The analysis refers to Neogene clays characterized by a complex structure, resulting directly from a complicated load history in the geological time scale and identified glacitectonic deformations. In the process of samples’ preparation for strength tests as well as during the interpretation of the post-failure state, particular attention was paid to the soil structure. The imaging methods (X-ray densitometry and computer microtomography) enabled the comparison of the soil structure and the selection of samples with similar characteristics. The completed program of strength tests consisted of two series of tests in the triaxial stress state, differentiated by the occurrence of the initial creep stage, preceding the typical strength test scheme under undrained conditions. This study allowed to obtain a quantitative assessment of the influence of the creep process on the strength parameters of tested soils. Constant stress lower than 60% of the shear stress deviator leads to the deceleration creep course (m parameter 0.64–0.89). As a result, higher values of internal friction angle (20% increase comparing to triaxial tests without creep stage) and cohesion reduction are obtained from triaxial creep tests. Creep parameter m is found to be a valuable indicator for differentiation of landslide activity trend. The tests proved low values of axial strains (1–5%) at failure, which was associated with lithogenesis. By the implementation of obtained strength parameters into the 3D finite element model of the slope, the potential influence of the creep process on the stability of an exemplary cross section of the Warsaw slope could be determined. |
|---|