Influence of the Chromium Content in Low-Alloyed Cu–Cr Alloys on the Structural Changes, Phase Transformations and Properties in Equal-Channel Angular Pressing
The quantitative concentration of alloying elements in low-alloyed copper alloys is an important factor in forming electrical and mechanical characteristics. It is known that severe plastic deformation is accompanied by both a substantial refinement of the structure and changes in the kinetics of ph...
Guardado en:
| Autores principales: | , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
MDPI AG
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/65ead71c4d6141808b0a919134a04cc9 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | The quantitative concentration of alloying elements in low-alloyed copper alloys is an important factor in forming electrical and mechanical characteristics. It is known that severe plastic deformation is accompanied by both a substantial refinement of the structure and changes in the kinetics of phase transformations during the deformation and the post-deformation thermal treatment. This paper presents the results of a comparative analysis of the Cu–0.2Cr and Cu–1.1Cr alloys subjected to equal-channel angular pressing at room temperature. The analysis was performed for the grain structure, solid solution, and second-phase particles using transmission electron microscopy, scanning electron microscopy, X-ray crystal analysis, and the small-angle diffraction method. It was found that the level of structure refinement and mechanical characteristics after equal-channel angular pressing was almost the same for both studied alloys. Post-deformation aging of the Cu–0.2Cr alloy leads to the development of polygonization and re-crystallization within it. The aging of the Cu–1.1Cr alloy shows a better thermal stability than that of the Cu–0.2Cr alloy. In the Cu–1.1Cr alloy, after aging, in comparison with Cu–0.2Cr, a denser-packed ensemble of fine particles with an average size of 54 ± 2 nm is formed. In this case, the average size of fragments is 270 ± 15 nm and the ultimate tensile strength reaches 485 MPa. |
|---|