Medium-velocity superconducting cavity for high accelerating gradient continuous-wave hadron linear accelerators
We present the first rf studies of the medium-β superconducting radio frequency (SRF) elliptical cavities designed for Michigan State University’s Facility for Rare Isotope Beams (FRIB) energy upgrade linac. The proposed energy upgrade for this continuous-wave (CW) superconducting linac will double...
Guardado en:
| Autores principales: | , , , , , , , , , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
American Physical Society
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/6bc0ccf5b4644b41a6b5dfe56af0a032 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | We present the first rf studies of the medium-β superconducting radio frequency (SRF) elliptical cavities designed for Michigan State University’s Facility for Rare Isotope Beams (FRIB) energy upgrade linac. The proposed energy upgrade for this continuous-wave (CW) superconducting linac will double the final beam energy from 200 to 400 MeV/u for the heaviest uranium ions within the 80 m of space available in the FRIB tunnel. Two prototype β_{opt}=0.65 644 MHz five-cell elliptical SRF cavities were fabricated and tested to validate the novel cavity design with three conventional rf recipes: (1) Electropolishing (EP-only), (2) EP+48 h 120 °C bake (EP+baking), and (3) Buffered chemical Polishing+48 h 120 °C bake (BCP+baking). The EP-only recipe achieved a 2 K quality factor (Q_{0}) of 2.3×10^{10} at the FRIB energy upgrade design accelerating gradient (E_{acc}) of 17.5 MV/m, and Q_{0} of 1.2×10^{10} at a maximum gradient of 26 MV/m, where the gradient was ultimately limited by the available rf amplifier power available for this test. These results validate the potential of the novel 644 MHz medium-β cavity design and motivate its use in future high-Q_{0} development work. The multipacting band, which exists at E_{acc}≈10 MV/m, was completely conditioned in the continuous-wave mode. We also observed that combining the 48 h 120 °C baking treatment with EP did not improve the EP-only cavity performance at 2 K due to increased residual resistance (R_{0}) and increased medium-field Q-slope. BCP+baking was also found to produce lower Q_{0} in this cavity due to increased medium-field Q-slope. The mechanical modes of this cavity were measured at room temperature, verifying that the quality factor of the dominant “accordion” mechanical mode these medium-β cavities are particularly vulnerable to is close to that of the 1.3 GHz TESLA cavities. Thus, this mode arising from the novel geometry of these cavities is shown to not be of excessive concern for resonance control. |
|---|