Optimization of Cutting Process of Medium Density Fibreboards by the Abrasive Water-Jet
This paper deals with the process of MDF cutting by the abrasive water-jet (WJC) and shows how is kerf width infl uenced by process parameters. It presents the results of monitoring the kerf width related to technical and technological parameters, material parameters and cutting method. At the end o...
Guardado en:
Autores principales: | Štefan Barcík, Monika Kvietková, Richard Kminiak, Patrik Aláč |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
University of Zagreb, Faculty of Forestry and Wood Technology
2011
|
Materias: | |
Acceso en línea: | https://doaj.org/article/8a9902e16dae4e469c32ca51623c406d |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Notes on the Abrasive Water Jet (AWJ) Machining
por: Lucie Gembalová, et al.
Publicado: (2021) -
NEW CHALLENGES IN ABRASIVE WATER JET MACHINING
por: CATALINA CIOFU, et al.
Publicado: (2019) -
Development of novel tool for cutting of carbon-fiber-reinforced plastics (Positive use of abrasive wear at tool edge for reduction in cutting force)
por: Satoru MAEGAWA, et al.
Publicado: (2015) -
Life Cycle Environmental and Economic Comparison of Water Droplet Machining and Traditional Abrasive Waterjet Cutting
por: Giovanni Guglielmi, et al.
Publicado: (2021) -
Effect of technological parameters and wood properties on cutting power in plane milling of juvenile poplar wood
por: Barcík Štefan, et al.
Publicado: (2008)