Application of Neural Network in Simple Tool Wear Monitoring and Indentification System in MDF Milling

This paper deals with simple neural network-based diagnostic system, applied to tool wear prediction in MDF milling. Ten tools were used for the test, and each one was consequently worn in the process of MDF milling. During the wearing process, the key process parameters were measured, such as cutti...

Descripción completa

Guardado en:
Detalles Bibliográficos
Autor principal: Marcin Zbieć
Formato: article
Lenguaje:EN
Publicado: University of Zagreb, Faculty of Forestry and Wood Technology 2011
Materias:
Acceso en línea:https://doaj.org/article/8cb2d55c1c294407bc5c0dc31c6c9ca7
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Descripción
Sumario:This paper deals with simple neural network-based diagnostic system, applied to tool wear prediction in MDF milling. Ten tools were used for the test, and each one was consequently worn in the process of MDF milling. During the wearing process, the key process parameters were measured, such as cutting and thrust forces, temperature and power consumption. The neural network-based system was used for tool wear prediction of all the tools except the fi rst one, based on data collected during the previous attempts. The test has shown that the proposed system has good prediction accuracy and that it could be a useful tool in the optimization of the woodworking process.