High Sensitivity of Ammonia Sensor through 2D Black Phosphorus/Polyaniline Nanocomposite
Recently, as a two-dimensional (2D) material, black phosphorous (BP) has attracted more and more attention. However, few efforts have been made to investigate the BP/polyaniline (PANI) nanocomposite for ammonia (NH<sub>3</sub>) gas sensors. In this work, the BP/PANI nanocomposite as a no...
Guardado en:
| Autores principales: | , , , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
MDPI AG
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/96d4700aa9ea407ba2aabb8f139ce6db |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Recently, as a two-dimensional (2D) material, black phosphorous (BP) has attracted more and more attention. However, few efforts have been made to investigate the BP/polyaniline (PANI) nanocomposite for ammonia (NH<sub>3</sub>) gas sensors. In this work, the BP/PANI nanocomposite as a novel sensing material for NH<sub>3</sub> detection, has been synthesized via in situ chemical oxidative polymerization, which is then fabricated onto the interdigitated transducer (IDTs). The electrical properties of the BP/PANI thin film are studied in a large detection range from 1 to 4000 ppm, such as conduction mechanism, response, reproducibility, and selectivity. The experimental result indicates that the BP/PANI sensor shows higher sensitivity and larger detection range than that of PANI. The BP added into PANI, that may enlarge the specific surface area, obtain the special trough structure for gas channels, and form the <i>p–π</i> conjugation system and <i>p–p</i> isotype heterojunctions, which are beneficial to increase the response of BP/PANI to NH<sub>3</sub> sensing. Meanwhile, in order to support the discussion result, the structure and morphology of the BP/PANI are respectively measured by Fourier transform infrared spectroscopy (FTIR), ultraviolet-visible spectroscopy (UV−vis), transmission electron microscopy (TEM), and field emissions scanning electron microscopy (SEM). Moreover, the sensor shows good reproducibility, and fast response and recovery behavior, on NH<sub>3</sub> sensing. In addition, this route may offer the advantages of an NH<sub>3</sub> sensor, which are of simple structure, low cost, easy to assemble, and operate at room temperature. |
|---|