Center Impedance Method for Estimating Complex Modulus with Wide Frequency Range and Large Loss Factors
A simple method for determining viscoelasticity over a wide frequency range using the frequency response function (FRF) mobility obtained by the center impedance method is presented. As user data comprise the FRF between the velocity of the excitation rod and excitation force, it is challenging to s...
Guardado en:
| Autores principales: | , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Hindawi Limited
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/99ab7240ee484eaab012d4f03e2867d9 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | A simple method for determining viscoelasticity over a wide frequency range using the frequency response function (FRF) mobility obtained by the center impedance method is presented. As user data comprise the FRF between the velocity of the excitation rod and excitation force, it is challenging to separate the signal and noise. Our proposed method is based on the FRF obtained from the analytical solution of the equation of motion of the viscoelastic beam and relationship between the complex wavenumber (real wavenumber and attenuation constant) of flexural wave and viscoelasticity. Furthermore, a large loss factor can be handled over a wide frequency range without using the half-power bandwidth. In this study, actual FRF mobility data containing noise were processed using preprocessing, inverse calculation, and postprocessing. Preprocessing removed low-coherence data, compensates for the effects of instrument gain, and transformed the FRF into its dimensionless equivalent. Then, inverse calculations were used to solve the mobility equation and determine the complex wavenumber. In postprocessing, the complex wavenumber obtained by the inverse calculation was curve fitted using functions with mechanical significance. Consequently, the storage modulus based on the curve-fitted complex wavenumber was a monotonically increasing frequency function. The loss factor had a smooth frequency dependence such that it has the maximum value at a single frequency. The proposed method can be applied to composite materials, where the application of time-temperature superposition is challenging. We utilized the measured FRF mobility data obtained over a duration of several seconds, and this method can also be applied to materials with large loss factors of 1 or more. |
|---|