Fanless, porous graphene-copper composite heat sink for micro devices
Abstract Thermal management in devices directly affects their performance, but it is difficult to apply conventional cooling methods such as the use of cooling liquids or fans to micro devices owing to the small size of micro devices. In this study, we attempted to solve this problem by employing a...
Guardado en:
| Autores principales: | , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Nature Portfolio
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/a6a7110845c84490bdc8b7b1c73e1b86 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Abstract Thermal management in devices directly affects their performance, but it is difficult to apply conventional cooling methods such as the use of cooling liquids or fans to micro devices owing to the small size of micro devices. In this study, we attempted to solve this problem by employing a heat sink fabricated using copper with porous structures consisting of single-layer graphene on the surface and graphene oxide inside the pores. The porous copper/single-layer graphene/graphene oxide composite (p-Cu/G/rGO) had a porosity of approximately 35%, and the measured pore size was approximately 10 to 100 µm. The internal GO was reduced at a temperature of 1000 °C. On observing the heat distribution in the structure using a thermal imaging camera, we could observe that the p-Cu/G/rGO was conducting heat faster than the p-Cu, which was consistent with the simulation. Furthermore, the thermal resistance of p-Cu/G/rGO was lower than those of the p-Cu and pure Cu. When the p-Cu/G/rGO was fabricated into a heat sink to mount the light emitting diode (LED) chip, the measured temperature of the LED was 31.04 °C, which was less than the temperature of the pure Cu of 40.8 °C. After a week of being subjected to high power (1000 mA), the light intensity of p-Cu/G/rGO decreased to 95.24%. However, the pure Cu decreased significantly to 66.04%. The results of this study are expected to be applied to micro devices for their effective thermal management. |
|---|