Design For Manufacture And Assembly Analysis of the Tray for Vertical Lift Modules
This paper addresses the analysis of the design, manufacture, and assembly (DFMA) of the tray for a vertical lift module (Tray VLM), being a subassembly of this automatic VLM storage system. The method used for DFMA analysis is the Boothroyd Dewhurst method, using their software. Based on the rec...
Guardado en:
| Autores principales: | , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
THOT Publishing House
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/a6a9508faf884a729fd55388da898b34 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | This paper addresses the analysis of the design, manufacture, and assembly (DFMA)
of the tray for a vertical lift module (Tray VLM), being a subassembly of this automatic VLM
storage system. The method used for DFMA analysis is the Boothroyd Dewhurst method, using
their software. Based on the recommendations of the DFMA software, following the study on
the current Tray VLM product, several components were redesigned using the Design for
Manufacture (DFM) module and certain stages for assembly were optimized, using the design
for Assembly module (DFA). The result was reduced assembly cost, reduced assembly process
time, and increased assembly design efficiency, which were successfully validated by DFMA
software by maximizing the DFA index |
|---|