Characterization of the bond quality of adhesive plates utilizing zero-group-velocity Lamb waves measured by a laser ultrasonics technique
The bonding quality of an adhesive component was estimated using the frequency of zero-group-velocity (ZGV) Lamb waves, which can be generated and detected with a laser ultrasonic technique. Two distinct peaks corresponding to ZGV Lamb waves in the amplitude spectrum were obtained for well- and weak...
Guardado en:
| Autores principales: | , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
The Japan Society of Mechanical Engineers
2014
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/b5974ed818c74bf29ff3f908d990165f |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | The bonding quality of an adhesive component was estimated using the frequency of zero-group-velocity (ZGV) Lamb waves, which can be generated and detected with a laser ultrasonic technique. Two distinct peaks corresponding to ZGV Lamb waves in the amplitude spectrum were obtained for well- and weak-bonded adhesive plate samples. The frequency difference between the measured low frequency mode and the calculated frequency, which can be obtained by assuming a continuous stress and strain at a bonding interface, linearly increased with shear strength, as obtained by the shear-tensile test. The frequency of ZGV Lamb waves was also calculated with reduced shear modulus of the bonding layer to express a weak bonding, and the change in the calculated frequency in low frequency ZGV Lamb waves showed a similar tendency to that in measured one. |
|---|