The effect of different fuels and clads on neutronic calculations in a boiling water reactor using the Monte Carlo method
Abstract In this study, a Boiling Water Reactor (BWR) modeling was done for the reactor core divided into square lattice 8 × 8 type using the Monte Carlo Method. Each of the square lattices in the reactor core was divided into small square lattices 7 × 7 type in groups of four. In the BWR designed i...
Guardado en:
| Autores principales: | , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Nature Portfolio
2020
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/c945b9a178d04760818ce815d5ae78fa |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Abstract In this study, a Boiling Water Reactor (BWR) modeling was done for the reactor core divided into square lattice 8 × 8 type using the Monte Carlo Method. Each of the square lattices in the reactor core was divided into small square lattices 7 × 7 type in groups of four. In the BWR designed in this study, modeling was made on fuel assemblies at pin-by-pin level by using neptunium mixed fuels as fuel rod, Zr-2 and SiC as fuel cladding, H2O as coolant. In fuel rods were used NpO2 and NpF4 fuels at the rate of 0.2%-1% as neptunium mixed fuels. In this study, the effect on the neutronic calculations as keff, neutron flux, fission energy, heating of NpO2 and NpF4 fuels in 0.2%-1% rates, and Zr-2 and SiC clads were investigated in the designed BWR system. The three-dimensional (3-D) modelling of the reactor core and fuel assembly into the designed BWR system was performed by using MCNPX-2.7.0 Monte Carlo method and the ENDF/B-VII.0 nuclear data library. |
|---|