Formation of residual stresses during discontinuous friction treatment
The tool with grooves on its working surface is used to improve the properties of the strengthened layer. This allows us to reduce the structure’s grain size and increase the thickness of the layer and its hardness. Mineral oil and mineral oil with active additives containing polymers are used as a...
Guardado en:
Autores principales: | Hurey I., Gurey V., Bartoszuk M., Hurey T. |
---|---|
Formato: | article |
Lenguaje: | EN RU UK |
Publicado: |
Sumy State University
2021
|
Materias: | |
Acceso en línea: | https://doaj.org/article/ca4ae7ed1ef64c19bb6013f94630c667 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Microstructures, mechanical, and biological properties of a novel Ti-6V-4V/zinc surface nanocomposite prepared by friction stir processing
por: Zhu C, et al.
Publicado: (2018) -
Contribution to Improvement of Fatigue Properties of Zr-4 Alloy: Gradient Nanostructured Surface Layer versus Compressive Residual Stress
por: Donghui Geng, et al.
Publicado: (2021) -
Redistribution of Grain Boundary Misorientation and Residual Stresses of Thermomechanically Simulated Welding in an Intercritically Reheated Coarse Grained Heat Affected Zone
por: Giancarlo Sanchez Chavez, et al.
Publicado: (2021) -
Some properties of state filters in state residuated lattices
por: Michiro Kondo
Publicado: (2021) -
Determination of the effect of thickness reduction ratio, die angle, and coefficient of friction on residual stresses in ironing process: an analysis using computer simulation
por: Akhmad Faizin, et al.
Publicado: (2021)