INVESTIGATION ON LAMINATED WOOD (LB, LVL) MANUFACTURING

Laminated beam ( LB.) and laminated veneer lumber ( LVL) manufactured from maple, hornbeam and beech wood is investigated. Three levels of press pressures at 30, 35, 40 kg/cm2, three levels of layer thicknesses of 2, 3, 4 mm and tangential and radial layers are investigated. Bending strength (MOR an...

Descripción completa

Guardado en:
Detalles Bibliográficos
Autores principales: Ahmad Jahan latibari, Habibalah Arabtabar, Fardad Golbabaei, Abolfazl Kargarfard, Amir Nourbakhsh, Abbas Fakhryan roghani
Formato: article
Lenguaje:FA
Publicado: Regional Information Center for Science and Technology (RICeST) 2001
Materias:
Acceso en línea:https://doaj.org/article/cbd4356c8cd14bc08d4397cd55aea98d
Etiquetas: Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
Descripción
Sumario:Laminated beam ( LB.) and laminated veneer lumber ( LVL) manufactured from maple, hornbeam and beech wood is investigated. Three levels of press pressures at 30, 35, 40 kg/cm2, three levels of layer thicknesses of 2, 3, 4 mm and tangential and radial layers are investigated. Bending strength (MOR and MOE) and shear strength were measured according to ASTM 1186 and 905 respectively.The results of this investigation indicated that laminated wood strength of samples produced from hornbeam layers is superior to beech and beech is superior to maple. Statistical analysis of the results showed that the effect of wood species on strength properties is significantly different at 99% level. Press pressure also showed significant effect on strength. Increasing press pressure improved bending properties, but the highest shear strength was observed at 30 kg/cm2. Cutting direction did not influence bending strength and only influenced the shear strength. Even though the initial anticipation was the fact that thinner layer will produce stronger laminated wood. But the results or this study showed that layer thickness did not significantly affect strength properties.