Numerical and experimental investigations of built orientation dependent Johnson–Cook model for selective laser melting manufactured AlSi10Mg
Powder bed fusion based additive manufacturing techniques involve melting or sintering of powder particles via laser beams to join them in order to attain desired shapes. This study aims to provide basis for material constitutive parameters of widely used aluminum alloy AlSi10Mg alloy. Initially, te...
Guardado en:
| Autores principales: | , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Elsevier
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/e19579e6737944448ee9f22ad8848f77 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Powder bed fusion based additive manufacturing techniques involve melting or sintering of powder particles via laser beams to join them in order to attain desired shapes. This study aims to provide basis for material constitutive parameters of widely used aluminum alloy AlSi10Mg alloy. Initially, tensile samples of AlSi10Mg alloy samples were manufactured by using SLM technology. Afterwards, through quasi-static and high temperature tensile tests, an attempt has been made to determine the Johnson–Cook material model of AlSi10Mg. in order to conduct quasi-static tensile tests, strain rates of 10−3 s−1, 10−2 s−1 and 5 × 10−2 s−1 were considered and tests were conducted at ambient temperature. Whereas, for high temperature tensile tests 24, 150, 300 °C temperature values were considered at the reference strain rate value of 10−3 s−1. The numerically simulated tensile results achieved by using the established Johnson–Cook model were then compared with experimental results. It was observed that the maximum error between the test and simulation results was around of 7.5%. The error percentage is well within the acceptable, thus proving the accuracy of the established material model. |
|---|