Formation of Compressive Residual Stress by Face Milling Steel AISI 1045
Machining residual stresses correlate very closely with the cutting parameters and the tool geometries. This research work aims to investigate the effect of cutting speed, feed rate and depth of cut on the surface residual stress of steel AISI 1045 after face milling operation. After each milling te...
Guardado en:
Autores principales: | Samir Zidan Al-Fahadawy, Samir Ali Al-Rabii, Ahmed Naif Al-Khazraji |
---|---|
Formato: | article |
Lenguaje: | EN |
Publicado: |
Al-Khwarizmi College of Engineering – University of Baghdad
2015
|
Materias: | |
Acceso en línea: | https://doaj.org/article/e76064f2b9104762a147a7cc4479aaab |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
Formation of Compressive Residual Stress by Face Milling Steel AISI 1045
por: Ahmed Naif Al-Khazraji, et al.
Publicado: (2017) -
Enhancement of Buckling Resistance of Aluminized Long Columns of Stainless Steel AISI 303
por: Ahmed Naïf Al-Khazraji, et al.
Publicado: (2016) -
Improvement of Dynamic Buckling Behavior of Intermediate Aluminized Stainless Steel Columns
por: Ahmed Naif Al-Khazraji, et al.
Publicado: (2017) -
Experimental Modeling and Optimization of Fatigue Life and Hardness of Carbon Steel CK35 under Dynamic Buckling
por: Ahmed Naif Al-Khazraji
Publicado: (2014) -
Optimization of Wear Parameters in AISI 4340 Steel
por: Abbas Khammas Hussein
Publicado: (2014)