STUDY ON THE POSSIBILITY OF MANUFACTURING PARTICLEBOARD WITH PAPER SLUDGE AND WOOD CHIPS
Beneficial utilization of large quantity of paper sludge from Mazandaran Wood & Paper Industry in particleboard manufacturing has been studied. Single-layer and three-layer particleboard (paper sludge as a surface layer) were produced. Urea-formaldehyde resin at two levels of 10 and 12 percent a...
Guardado en:
| Autores principales: | , , , |
|---|---|
| Formato: | article |
| Lenguaje: | FA |
| Publicado: |
Regional Information Center for Science and Technology (RICeST)
2004
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/f8a0894950b448b9939c2b688393dd9f |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Beneficial utilization of large quantity of paper sludge from Mazandaran Wood & Paper Industry in particleboard manufacturing has been studied. Single-layer and three-layer particleboard (paper sludge as a surface layer) were produced. Urea-formaldehyde resin at two levels of 10 and 12 percent and paper sludge content at 4 levels, 0, 15, 30 and 45 percent were studied. Other factors such as press temperature (160oC), press time (6minutes), mat moisture (12%), board density (0.75g/cm3) and etc were constant factors. Mechanical and physical properties including bending strength, shear strength, thickness swelling and water absorption after 2 and 24 hours immersion were evaluated. The results indicated that application of paper sludge reduced mechanical properties and improved thickness swelling .The particleboard produced with 15%paper sludge had the least water absorption, but by using more paper sludge, water absorption increased. Single-layer particleboard had higher bending strength. However, there was no significant different in shear strength between single and three layer particleboard. Three-layer particleboard showed lower thickness swelling. |
|---|