A TECHNIQUE OF MEASURING OF RESISTANCE OF A GROUNDING DEVICE
Introduction. Measurement of resistance of the grounding device (GD) by means of a three-electrode system. This requires not only the right choice of installation locations of measuring electrodes, but also the determination of the point of zero potential. Implementation of these requirements quite...
Guardado en:
Autores principales: | I.V. Nizhevskyi, V.I. Nizhevskyi |
---|---|
Formato: | article |
Lenguaje: | EN RU UK |
Publicado: |
National Technical University "Kharkiv Polytechnic Institute"
2016
|
Materias: | |
Acceso en línea: | https://doaj.org/article/f926026098094a81a2f4731278858912 |
Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
Ejemplares similares
-
A TECHNIQUE OF FULL-SCALE MEASUREMENTS OF THE RESISTANCE OF THE GROUNDING DEVICE
por: I. V. Nizhevskyi, et al.
Publicado: (2018) -
THE EXPERIMENTAL VALIDATION OF THE GROUNDING DEVICE RESISTANCE MEASUREMENT METHOD
por: I. V. Nizhevskyi, et al.
Publicado: (2016) -
Research on electric potentials alignment on the ground surface within the grounding conductor territory
por: I.V. Nizhevskyi, et al.
Publicado: (2014) -
INVESTIGATION AND CALCULATION OF VALLEYS OF OUTGOING FROM SUBSTATION GROUNDING CONDUCTORS FOR SHORT-CIRCUIT IN SINGLE-PHASE SHORT OF ELECTRICAL GRID
por: V. I. Nizhevskyi, et al.
Publicado: (2015) -
MODERNIZATION OF THE COMPLEX TYPE IK-1U FOR MEASURING THE IMPEDANCE OF THE GROUNDING DEVICE OF A LIGHTNING ARRESTER AND SUPPORTS OF TRANSMISSION LINES
por: D. G. Koliushko, et al.
Publicado: (2019)