Strain Rate and Temperature Effects on Tensile Properties of Polycrystalline Cu<sub>6</sub>Sn<sub>5</sub> by Molecular Dynamic Simulation
Intermetallic compounds (IMCs) are essential in the soldering of electronic products and are composed mainly of Cu<sub>6</sub>Sn<sub>5</sub> and Cu<sub>3</sub>Sn. They must maintain reliable mechanical and electrical connections. As they are usually only a few mic...
Guardado en:
| Autores principales: | , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
MDPI AG
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/02afbf5cd7ac4268ba22781c1116e9fa |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Intermetallic compounds (IMCs) are essential in the soldering of electronic products and are composed mainly of Cu<sub>6</sub>Sn<sub>5</sub> and Cu<sub>3</sub>Sn. They must maintain reliable mechanical and electrical connections. As they are usually only a few microns thick, and it is difficult to study their mechanical properties by traditional methods. In this study, a 100 Å × 100 Å × 100 Å polycrystal with 10 grains was created by Atomsk through Voronoi tessellation based on a Cu<sub>6</sub>Sn<sub>5</sub> unit cell. The effects of the temperature and strain rate on the tensile properties of the polycrystalline Cu<sub>6</sub>Sn<sub>5</sub> were analyzed based on MEAM potential function using a molecular dynamics (MD) method. The results show that Young’s modulus and ultimate tensile strength (UTS) of the polycrystalline Cu<sub>6</sub>Sn<sub>5</sub> decrease approximately linearly with an increase in temperature. At high strain rates (0.001–100 ps<sup>−1</sup>), Young’s modulus and UTS of the Cu<sub>6</sub>Sn<sub>5</sub> are logarithmic with respect to the strain rate, and both increase with an increase in strain rate. In addition, at low strain rates (0.00001–0.0005 ps<sup>−1</sup>), the UTS has a quadratic increase as the strain rate increases. |
|---|