Gate energy efficiency and negative capacitance in ferroelectric 2D/2D TFET from cryogenic to high temperatures
Abstract We report the fabrication process and performance characterization of a fully integrated ferroelectric gate stack in a WSe2/SnSe2 Tunnel FETs (TFETs). The energy behavior of the gate stack during charging and discharging, together with the energy loss of a switching cycle and gate energy ef...
Guardado en:
| Autores principales: | , , , , , , |
|---|---|
| Formato: | article |
| Lenguaje: | EN |
| Publicado: |
Nature Portfolio
2021
|
| Materias: | |
| Acceso en línea: | https://doaj.org/article/f68372b2b4fd4e2db205ac95097f52d8 |
| Etiquetas: |
Agregar Etiqueta
Sin Etiquetas, Sea el primero en etiquetar este registro!
|
| Sumario: | Abstract We report the fabrication process and performance characterization of a fully integrated ferroelectric gate stack in a WSe2/SnSe2 Tunnel FETs (TFETs). The energy behavior of the gate stack during charging and discharging, together with the energy loss of a switching cycle and gate energy efficiency factor are experimentally extracted over a broad range of temperatures, from cryogenic temperature (77 K) up to 100 °C. The obtained results confirm that the linear polarizability is maintained over all the investigated range of temperature, being inversely proportional to the temperature T of the ferroelectric stack. We show that a lower-hysteresis behavior is a sine-qua-non condition for an improved energy efficiency, suggesting the high interest in a true NC operation regime. A pulsed measurement technique shows the possibility to achieve a hysteresis-free negative capacitance (NC) effect on ferroelectric 2D/2D TFETs. This enables sub-15 mV dec−1 point subthreshold slope, 20 mV dec−1 average swing over two decades of current, I ON of the order of 100 nA µm−2 and I ON/I OFF > 104 at V d = 1 V. Moreover, an average swing smaller than 10 mV dec−1 over 1.5 decades of current is also obtained in a NC TFET with a hysteresis of 1 V. An analog current efficiency factor, up to 50 and 100 V−1, is achieved in hysteresis-free NC-TFETs. The reported results highlight that operating a ferroelectric gate stack steep slope switch in the NC may allow combined switching energy efficiency and low energy loss, in the hysteresis-free regime. |
|---|